Fu_io_s se_ i_ the OPTIONMENU{go_fi_e_}
78
0 Notes
• Set [WHITE BAL. ] to [AUTO] or a_[iust tile
cok)r in [ONE PUSH] under white or cool white
fluorcscent lamps.
• While i:xmz:lis flashing quickly during [ONE
PUSHI _tting, continue to ffanle a while ohject
until t::_l!le.dslops flashing.
• Nm_ flashes slowly if [ONE PUSH] could not
he set.
• When [ONE PUSHI was selected, if ixmztkeeps
flashing al}er touching [_, set [WHITE BAL
I to [AUTOI.
• If you set [WHITE BAg. I, [SCENE
SELECTION] is automatically set to [AUTOf
"_° Tips
• It you change tile hattely pack with [AUTO]
_lected, or take yollr calllcorder Ollldoors af[er
inside tl_ (or vice versa h select [AUTOI and
aim your camcorder at a nearby white ohject fin.
abotll 10 seconds lor better color balance
adj ustlnent,
• ff you change the ]SCENE SELECTION]
_ttings or nlove your canlcorder otltdoors
during white balance setting with [ONE PUSHI,
you need to repeat the [ONE PUSHI operation.
When you set [COLOR SLOW SHTR] to
[ON], you can record an image brighter in
color even in dark places.
[-_'] appears on the screen.
To cancel [COLOR SLOW SHTR ], touch
[OFF].
Notes
• A@lst tile locus nlanually ([FOCUS], p. 75)
when it is hard to l_cus autonlatically.
• Tile shutter spe_d of your camcorder changes
depending on the brighmess, which nlay rcsu]l
in a slowdown of the motion of tile inlage.
The ilnage will be recorded at a nmximum
of 16 times the sensitivily of NightShot plus
recording if you sel IS. NIGHTSHOT PLS]
to [ON]while the NIGHTSHOT PLUS
switch (p. 37) is also setto ON.
S{_ appears on the screen.
To return to the nonnal setting, set IS.
NIGHTSHOT PLS] to [OFF].
0 Notes
• Do not use IS. NIGHTSHOT PLS] in hright
places. This nlay ca,use a malfimction.
• Do not cover tile inliared port with your fingers
or other ohjects (p. I12).
• Adjust the lbcus manually ([FOCUSI, p. 75)
when it is hard to locus automatically.
• The shuttcr speed of your canlcorder changes
depending on the brightness, which may resuh
ill a slowdown of tile nlotion of tile image,
You can record a transition with the
following effects addin_ to the interval
between scenes.
(_) Select the desired effect in [STBY] (during
fiJding in) or [REC] (during fading out)
mode, then touch [_].
@ Press START/STOP.
The fader indicator stops fl ishing and
disappears when the fade is complete.
To cancel the fader before starting the
operation, touch [OFF] in step @.
If you press START/STOP. the setting is
canceled.
Fading out
WHITE FADER
BLACK FADER
Fading in
To Next Page
Loading...
Need help?
General