SA-Z9R
16
2-11. SK2 REAR MAIN BOARD
:LUHVHWWLQJ
CN8025
top side
MAIN board
NG
The harness (SMPS~REAR-AMP)
is folded in the direction of the
arrow below.
–5LJKWYLHZ–
front side
rear side
top side
left side
right side
Press.
Press.
1 speaker
connection
cable
connector
(CN8009)
2
harness
(SMPS~REAR-AMP)
connector
(CN8025)
Attach in order from 1 to 3.
1
Fold the harness (SMPS~REAR-AMP)
in the direction of the arrow.
2
Fold the harness (SMPS~REAR-AMP)
in the direction of the arrow.
3
Press.
+RZWRLQVWDOOWKHSDFNLQJ
PDLQ
left side
3
Unlock the connector (CN8022).
5
absorbent (FFC) (short)
(Refer to “Processing method when
replacing the FFC (REAR-AMP~
WSMODULE) (50P)” )
terminal side
When replacing the FFC (REAR-AMP~WSMODULE) (50P)
to a new part, according to the step 1 to 3 figure below,
process the FFC (REAR-AMP~WSMODULE) (50P).
5 absorbent (FFC) (long)
(Refer to “Processing method when
replacing the FFC (REAR-AMP~
WSMODULE) (50P)” )
6 FFC (REAR-AMP~WSMODULE) (50P)
(Refer to “Processing method when
replacing the FFC (REAR-AMP~WSMODULE) (50P)” )
7 punching (main)
8 two screws
(BVTP3 u 8)
9 heat sink (main)
notch
notch
rib
rib
q; SK2 REAR MAIN board
Note 2:
When installing the SK2 REAR
MAIN board, align the two ribs
and two notches.
4
Draw out FFC block
from the connector
(CN8022).
FFC block
connector (
CN8022
)
terminal side
front side
no word side
3URFHVVLQJPHWKRGZKHQUHSODFLQJWKH
))&5($5$03a:602'8/(3
absorbent (FFC) (long)
Turn over.
38 mm
38 mm
1
Paste absorbent
(FFC) (long) on the
no word side of the
FFC, and turn over it.
2
Paste absorbent
(FFC) (short) on the
word side of the FFC
with aligning to
the guide line.
3
Bend at the position
38 mm from both
ends of the FFC,
and crease it.
Note 3:
Be sure to paste absorbent (FFC) (long)
on the no word side of the FFC.
absorbent
(FFC) (short)
word side
guide line
Note 1: When the SK2 REAR MAIN board is replaced, spread the compound
to the touching portion between the IC8010 and the heat sink.
To Next Page
Loading...
Need help?
General
