18
2 Fix the cord of an AC adapter with the cord
clamper so that it does not come out.
Unlock the cord clamper and put the cord
th
rough it.
Note
Do not use any AC adapter other than the
supplied AC adapter. Otherwise, a fire or
malfunction may occur.
Connecting the camera to a PoE+
(Power over Ethernet Plus) power
supply device
A PoE+ (IEEE802.3at compliant) power supply
device supplies power through a commercially
available network cable. For details, see the
operating instructions of the power supply
device.
Notes
• When you supply power from a PoE+ power
source, use a network cable of Category 5e or
higher.
• Do not have both the AC adapter and PoE+
p
ower supply connected at the same time.
• When power is supplied from PoE+, the POWER
la
mp (green) flashes until the initial verification
process is complete. The lamp flashes for
approximately 1 minute. However, this length
of time differs depending on the power supply
device.
• When the network camera is powered by a
P
oE+ power supply, do not route the wiring
outdoors.
• If a device not compatible with PoE+ is
c
onnected, the POWER lamp (green) flashes,
and the camera does not start.
• When you turn the power off, wait at least 10
se
conds before you turn it on again.
• Use an STP (shielded) network cable.
AC adapter cord
Cord clamper lock
AC adapter cord clamper
Unlock the cord
clamper lock.
Put the AC adapter cord through the cord clamper and
lock the cord clamper.
Network cable
(commercially
available)
Hub with PoE+ power
supply feature
To Next Page
Loading...
Need help?
General
