8
Infrared Remote Commander
(supplied)
CAMERA SELECT buttons
Press the button corresponding to the
c
amera you want to operate with the remote
commander. The camera number can be set
using the IR SELECT switch on the back of the
camera.
Note
If two or more cameras are adjacent and
have the same camera number, they are
operated simultaneously with the supplied
remote commander. When you install the
cameras close to each other, set different
camera numbers.
For setting of camera number, see
“Operating Multiple Cameras Using the
Infrared Remote Commander” (page 22).
FO
CUS buttons
Used for focus adjustment.
Press the AUTO button to adjust the focus
aut
omatically. To adjust the focus manually,
press the MANUAL button, and adjust it with
the FAR and NEAR buttons.
Note
Press the MANUAL button and adjust the
focus manually when shooting the following
objects.
• White walls and other objects without
con
trast
• Objects behind glass
• Objects with horizontal stripes
• Objects on which bright lights are cast or
re
flected
• Nightscapes and other dark objects with
b
linking lights
• Lit objects shot with darkened exposure
ad
justment or exposure compensation
settings
D
ATA SCREEN button
Press this button to display the main menu
P
AGE. Press it again to close the menu. If you
press the button when a lower-level menu is
selected, the display goes back to a higher-
level menu.
Note
You cannot perform pan/tilt/zoom
operations while the menu is displayed.
PA
N-TILT button
Press the arrow buttons to pan or tilt the
c
amera. Press the HOME button to face the
camera back to the front.
When the menu is displayed, use or to
select the menu items and or to change
the set values.
The selected setting menu is displayed by
p
ressing the HOME button when the main
menu is displayed.
L
/R DIRECTION SET button
Hold down this button and press the REV
bu
tton to change the direction of the camera
movement to be opposite the direction of
the arrows on the and buttons. To reset
the direction of the camera movement, press
the STD button while holding down this
button.
PO
WER button
Press this button to turn on power or to put
t
he camera in the standby mode.
BA
CK LIGHT button
Press this button to enable backlight
c
ompensation. Press it again to disable
backlight compensation.
Note
The BACK LIGHT button is enabled when
MODE (Exposure mode) on the EXPOSURE
menu is set to [FULL AUTO] (Full auto),
[SHUTTER Pri] (Shutter priority), or [IRIS Pri]
(Iris priority).
To Next Page
Loading...
Need help?
General
