Hooking Up
the
Components
This chapter describes how to connect
various audio and video components
to the receiver. Be sure to read the
sections for the components you have
before you actually connect them to
the receiver.
Unpacking
Check that you received the following items with the
remote:
• FM wire antenna (l)
• AM loop antenna (1)
• 1,R6 (size-AA) alkaline batteries (3)
Models of area code U, CA onh,
• Audk)/vide_}/control S connecting cord (1)
• Control S connecting c_rd (1 }
STR-DE945 only
• Remote commander RM-L]304 (remote) (1)
STR-DE845 only
• Remote commander RM-LP204 (remote) (1)
Inserting batteries into the remote
Insert LR6 (size-AA) alkaline batteries with the + and -
properly oriented in the battery compartment. When
using the remote, point it at the remote sensor [] on the
receiver.
For details, refer to the operating instructions supplied
with your remote.
"_1"When to replace batteries
Under normal conditions, the batteries should last for about
3 months. When the remote no longer operates the receiver,
replace all batteries with new ones.
Notes
• Do not leave the remote in an extremely hot or humid place.
• Do not use a new batte D' with an old one.
• Do not expose the remote _ensor to direct sunlight or lighting
apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
• This remote is designed for use with alkaline batteries only. Do
not use a combination of different battery types.
Before you get started
• Turn off the power to all components before making
any connections.
• Do not connect the AC power cord until all of the
connections are completed.
• Be sure to make connections firmly to avoid hum and
noise.
• When connecting an audio/video cord, be sure to
match the color-coded pins to the appropriate jacks on
the components: yellow (video) to yellow; white (left,
audio) to white; and red (right, audio) to red.
4
To Next Page
Loading...
Need help?
General
