Sony STR-DE845 - Using the SET up Button

Adjustments Using the SET UP Button
0
e_
=r
.m
0
®
0
The SET UP button allo'_vs vo_a to make the following
adjustments.
Selecting the 5.1CH video input
This parameter lets you specify the video input to be used
with the audio signals from the 5.1CH INPUT jack.
The 5.1CH video input is set to DVD/LD by default.
1 Press SET UP.
2 Pressthe cursor buttons (< or >) to select
5.1CH V: .
3 Turn the jog dial to select the video input you
desire.
Adjusting the Control A1 II auto function
Turning on the Control A1 I] auto function parameter lets
you turn Sony components connected via Control A1
cords (see page 13) on automatically when you press the
corresponding function button,
Auto function is set to ON by default.
1 Press SET UR
2 Press the cursor buttons (< or >) to select "AUTO
FUNCTION."
3 Turn thejog dial to select "ON" or "OFF."
Setting up the 2 way remote
(STR-DE945 only)
This receiver is shipped from the factory with tbe 2 way
remote control svstem set to "ON". Normany you can use
the receiver as is.
However, if you want to use this receiver together with
another component that is also compatible with the 2 way
remote control system, be sure to perform the following
operation to limit response to signals sent from the remote
controls.
To use with the TA-E900OES
Perform the following steps to turn OFF this unit's 2 way
remote control system. Also, be sure the TA-E9000E$ is
turned on when using this unit.
To use with other components that have the I_
logo
Turn OFF the other component'_ 2 way remote control
system. For details, refer to the operating instructions
suppled with your other components.
To use with Sony CD players CDP-CX260 or CDP-
CX88ES
Turn OFF the remote control adapter switch on the
CDP-CX260 or CDP-CX88ES. For details, refer to the
operating instructions suppled with the CDP-CX260 or
CDP-CX88ES.
Also when using several 2 way remote control system
components together, be sure to place them close together
in order to enable proper remote operation.
1 PressSETUR
2 Pressthe cursor buttons (< or _>) to select "2 WAY
REMOTE",
3 Turn the jog dial to select "ON" or "OFF".
5O