2-2
VPL-VW70
2-1-3. Model Name Display (Shop
Demonstration) Mode Setting
1. If the menu is being displayed, press the [MENU]
button to close the menu.
2. Press the buttons within 5 seconds in the following
order:
“ ” → “ ” → “ ” → “ ”
Even if the message “Not applicable!” is displayed,
ignore it. If the key operations failed, wait for at least 6
seconds since the last key is pressed, and perform the
key operations again.
3. “Which mode do you wish to display? Model Name
Display/Off” is displayed.
4. Select “Model Name Display”.
m
. To exit the Model Name Display mode, perform step 2.
“Which mode do you wish to display? Model Name
Display/Off” is displayed. Select “Off”.
. Before entering or exiting the SERVICE MODE, be sure
to select any input terminals other than HDMI1 and
HDMI2. Alternately, select the menus in the following
order: MENU/Function/Control for HDMI Setting/
Control for HDMI, and change the setup from ON to
OFF.
To Next Page
Loading...
Need help?
General
