XAV-701BT/741
5
6
SERVO board
23IOH[LEOHERDUGVHWWLQJ
OK
NG
adhesive (ST-854GH) tape
NG NGOK
Insert is shallow
Insert is straight
to the interior.
Insert is incline
connector
flexible borad flexible borad flexible borad
connector connector
Note 6:
When installing the flexible board, please install them correctly.
There is a possibility that this machine damages when not
correctly installing it.
Note 7:
When installing the OP flexible board,
Do not touch this portion.
Note 9:
Check that OP flexible board is not
caught in a lever (lock B).
lever (lock B) lever (lock B)
Note 8:
Arrange OP flexible board
under the chassis at this part.
1
adhesive (ST-854GH)
tape
4
two
toothed lock screws
(M1.7
u
2.5)
5
claw
SERVO board
SERVO board
OP flexible board
OK
NG
Solder remains.
Note 5: Check that solder
does not remain
in solder points.
Note 4: When assembling the SERVO board, remove the solder
of short-land after connecting the OP flexible board.
2
Solder the short-land.
Note 3:
When solder the short-land, be sure to refer to
“NOTE FOR FLEXIBLE BOARD OF THE
OPTICAL PICK-UP” of the servicing notes
(See page 2).
3
OP flexible board
(
CN2
)
OP flexible board
A
A
±'9'PHFKDQLVPGHFNEORFNERWWRPVLGHYLHZ±
Note 2:
Adhesive (ST-854GH) tape cannot
re-used. Please replace to brand-new
part ones adhesive (ST-854GH) tape
is removed.
2-3. SERVO BOARD-2
Note 1: Before disconnecting the OP fl exible board, solder the short-land.
To Next Page
Loading...
Need help?
General
