265
Field: Freeze in field units.
When the signal format is 3840×2160P 2SI, 1080P,
1080PsF, or 720P, the freeze timing cannot be specified.
To turn the afterimage portion into stardust
The afterimage portion becomes stardust, and gradually
disappears.
1
In the DME >Light/Trail >Motion Decay menu
(4153), press [Dust], turning it on.
2
Set the following parameters.
a) The way in which the afterimage disappears is affected by both the
motion decay [Video Decay] and [Decay Dust] parameter
adjustments.
Keyframe Strobe Settings
Enabling Keyframe Strobe automatically disables Trail,
Motion Decay, or Wind if it is set.
Applying the Keyframe Strobe effect
1
Open the DME >Light/Trail >KF Strobe menu (4154).
2
Press [KF Strobe], turning it on.
3
Set the following parameter.
a) 0.00 represents no afterimage. 100.00 represents no decay in the
afterimage.
Selecting the overlay priority for movie and
still images (video freeze image)
In the <Priority> group of the DME >Light/Trail >KF
Strobe menu (4154), select the way in which the images
are overlaid.
Over: The movie is on top, and the still image is
underneath.
Under: The movie is underneath, and the still image is on
top.
Mix: The movie and still images are mixed. You can set
the following parameter.
a) The 0.00 setting is the same as [Over]. 100.00 is the same as [Under].
Selecting the freeze timing
In the <KF Freeze Timing> group of the DME >Light/
Trail >KF Strobe menu (4154), select the timing for
freezing a keyframe strobe.
Frame: Freeze in frame units.
Field: Freeze in field units.
When the signal format is 3840×2160P 2SI, 1080P,
1080PsF, or 720P, the freeze timing cannot be specified.
Erasing the afterimages that remain in
memory whenever a keyframe is passed
In the DME >Light/Trail >KF Strobe menu (4154), press
[KF Strobe Eraser], turning it on.
When the effect passes a keyframe, the afterimage is
erased before writing a new afterimage.
To turn the afterimage portion into
stardust
The afterimage portion becomes stardust, and gradually
disappears.
1
In the DME >Light/Trail >KF Strobe menu (4154),
press [Dust], turning it on.
2
Set the following parameters.
Note
No. Parameter Adjustment
1 Decay Dust Amount of the afterimage
disappearing as stardust
a)
2 Dust Soft Timing with which stardust
disappears
3 Dust Size Size of stardust
4 Dust Aspect Aspect ratio of stardust
Note
No. Parameter Adjustment
1 Decay Degree of decay of the video signal
a)
No. Parameter Adjustment
1 Mix Mix amount of the still image with
respect to the movie
a)
Note
No. Parameter Adjustment
1KF Strobe
Dust
Amount of the afterimage
disappearing as stardust
a)
2 Dust Soft Timing with which stardust
disappears
3 Dust Size Size of stardust
To Next Page
Loading...
Need help?
General
