3–18 INSTRUMENTS AND CONTROLS
4WD - TOD*
The “4WD LOW” indicator comes on when
the 4WD switch is in “4L” position.
CAUTION
To shift into ‘4L’ or ‘4H’, completely
stop the vehicle and always press the
clutch pedal, for manual transmission,
or position the selector lever to “N”,
for automatic transmission, and turn
the 4WD switch to ‘4L’ or ‘4H’.
DIGITAL CLOCK
When the ignition switch is turned on, the
time will be digitally displayed on the clock
face below the tachomter. To set time, press
the knob for the following functions.
To advance the hour indicated, rotate the
adjusting knob counterclockwise while push-
ing the knob.
To advance the minute indicated, rotate the
adjusting knob clockwise while pushing the
knob.
NOTE
When disconnecting the battery or
replacing the fuse, the clock should
be adjusted again.
4WD INDICATOR
4WD - Part time
The “4WD HIGH” or “4WD LOW” indicator
comes on when the 4WD switch is in “4H”
or “4L” position.
CAUTION
Both “4WD HIGH” and “4WD LOW”
come on simultaneously when there
is malfunction in part time 4WD Sys-
tem.
K140_RHD_EN_03.p65 2004-11-11, ¿ÀÈÄ 4:0818
To Next Page
Loading...
Need help?
General
