ST STM32H735G-DK User Manual

1 Features
• STM32H735IGK6U microcontroller featuring 1 Mbyte of Flash memory and 564 Kbytes of SRAM in
UFBGA176+25 package
• 4.3" TFT 480×272 pixels colored LCD module with capacitive touch panel and RGB interface
• Ethernet compliant with IEEE-802.3-2002 and PoE (Power over Ethernet)
• USB OTG FS
• SAI audio codec
• One ST-MEMS digital microphone
• 512-Mbit Octal-SPI NOR Flash memory
•
128-Mbit HyperRAM
™
• Two user LEDs
• User and reset push-buttons
• Fan-out daughterboard
• Three CAN FDs
• Board connectors:
– USB FS Micro-AB
– USB ST-LINK Micro-B
– Ethernet RJ45
– Stereo headset jack including analog microphone input
– Audio header for external speakers
– microSD
™
card
– TAG connector 10-pin footprint
– SMA connector
– Arm
®
Cortex
®
10-pin 1.27 mm-pitch debug connector over STDC14 footprint
– ARDUINO
®
Uno V3 expansion connector
– STMod+ expansion connector
– Pmod
™
Type-2A and Type-4A expansion connector
– Audio MEMS daughterboard expansion connector
• Flexible power-supply options:
– STLINK-V3E USB connector
– USB OTG FS connector
– 5 V delivered by RJ45 (Power over Ethernet)
– 5 V delivered by ARDUINO
®
– USB charger
• On-board STLINK-V3E debugger/programmer with USB re-enumeration capability: mass storage, Virtual
COM port, and debug port
• Comprehensive free software libraries and examples available with the STM32CubeH7 MCU Package
• Support of a wide choice of Integrated Development Environments (IDEs) including IAR Embedded
Workbench
®
, MDK-ARM, and STM32CubeIDE
Note: Arm is a registered trademark of Arm Limited (or its subsidiaries) in the US and/or elsewhere.
UM2679
Features
UM2679 - Rev 1
page 2/42

ST STM32H735G-DK Specifications

General

Brand	ST
Model	STM32H735G-DK
Category	Motherboard
Language	English