55EN
5. OPERATION
5.3.5.
BLUETOOTH
®
®
BUTTON
The robot lawn mower handles automatically the Bluetooth
®
connection with external mobile devices. The
Bluetooth
®
connection is available at all times when the robot lawn mower is switched on. It is possible to
connect only one mobile device at a time to the robot lawn mower via Bluetooth
®
. The robot lawn mower
automatically disconnects from the device when the app is closed. The 'BLUETOOTH
®
' button (M) is used
only by the service centre for diagnostic purposes.
NOTE: For pairing the device with the robot lawn mower via Bluetooth
®
, see Par. 4.7.3 “Pairing”.
5.3.6.
The “ALARM” light icon (N) indicates an operating anomaly.
Procedure:
1. Press the “STOP” button (A) to open the cover (B) and access the control panel (C).
2. Check the alarm status through the red light icon (N), which can be lit either steady or ashing.
3. After resolving the fault, press the button (E) twice in rapid succession to reset the
alarm. The light icon (N) goes out, and the robot lawn mower can be restarted. If the icon (N) does
not go o, turn o the robot lawn mower using the button (E), wait a few seconds and
then switch the robot lawn mower on again using the "" button (E). If the problem persists,
contact a service centre.
NOTE: Details about anomalies are viewable on the App.
B
C
A
D
M
To Next Page
Loading...
Need help?
General
