EN - 7
6.5.
Do not touch the cutting means until the ignition
sharpening, balancing, repairing, reassembly
Always replace damaged, bent or worn cutting
means, together with their nuts and bolts, in
order to ensure they remain balanced.
Always use original cutting means bearing the
code indicated in the “Technical Data” table.
7. TRANSPORT, STORAGE AND DIS
POSAL
7.1. TRANSPORT
When handling the machine, always:
1. disengage the cutting means;
2. Bring the cutting means assembly to the highest position;
3. switch o the machine and remove the ignition key
4. disengage the drive (par. 4).
When transporting the machine on a vehicle or trailer, always:
• use an access ramp of suitable strength, width and length;
• load the machine with the engine switched o, with the key
removed from the ignition, without a driver and pushed by
an adequate number of people;
• close the fuel tap (if provided);
• lower the cutting means assembly;
• position it so that it does not cause a hazard to anyone;
• engage the transmission (par. 4);
• lock it rmly on the means of transport using ropes or
chains to prevent it from tipping over and possible damage.
7.2. STORAGE
When you intend to put your machine away for more than
30 days:
• Wait for the engine to cool
• Disconnect the battery cables and store it in a cool and
dry place.
• Empty the fuel tank and follow all the instructions in the
engine manual.
• Clean the machine thoroughly.
• Check the machine for any damage. If necessary, contact
the authorised service centre.
Store the machine:
• with the cutting means assembly lowered;
• in a dry place;
• protected from inclement weather;
• covered with a sheet if possible;
• in a place out of children's reach;
• making sure that keys or tools used for maintenance are
removed.
Before starting to use the machine again:
• check that there are no fuel leaks from the tubes, fuel
stopcock or carburettor:
• prepare the machine as described in chapter "5 Use of
the machine".
NOTE Ensure that the battery is fully charged at least once a
month and always before use.
NOTE Store the machine so as to avoid any risk in the event
of accidental contact with people, children or animals.
To Next Page
Loading...
Need help?
General
