EN - 8
8.
SOLUTION
1. The starter motor does not
turn.
Insuciently charged battery. Recharge the battery.
Badly connected battery. Check the connections
Fuse 5:A blown Replace the fuse
2. The starter motor turns, but the
engine fails to start
With ignition key in start position,
the starter motor turns, but the
engine fails to start.
Fuel tap closed Open the fuel tap.
Faulty fuel supply. - Check the level in the tank.
- Check the fuel lter.
Faulty ignition. - Check that the spark plug cap is
securely tted
- Check that the electrodes are
clean and have the correct gap.
3. Starting is dicult or the en-
gine runs erratically.
Carburation fault. Clean or replace the air lter.
4. Weak engine performance
during cutting.
Forward speed too high in rela-
tion to the cutting height.
Reduce advancing speed and/or
increase the cutting height.
5. Engine stops for no apparent
reason.
- Fuel has run out.
- Try restarting the engine.
Top up the fuel (if the problem per-
sists, contact an authorised service
centre).
6. Irregular cutting. Check the tyre pressure
Cutting means sharpening is
reduced.
Contact an Authorised Service
Centre.
High advancing speed in relation
to the height of the grass to be
cut.
Reduce advancing speed and/or
increase the cutting height.
The cutting means assembly is
full of grass.
- Wait for the grass to dry.
- Clean the cutting means assembly.
7. Unusual vibrations during use. - Cutting means incorrectly
balanced.
- Cutting means loose.
- Loose parts.
- Possible damage.
Contact an Authorised Service Cen-
tre for verications, replacements
or repairs.
8. When the engine is running,
the machine remains stationary
when the drive pedal is pressed.
"Transmission disengagement"
lever in disengaged position.
Engage the transmission.
If one of the problems listed below occurs, replace the relevant fuse.
9. No electrical function is opera-
tional. The battery is charged.
Fuse 5:A defect Replace the fuse 5:A.
NOTE If problems persist after having performed the de-
scribed operations, contact your dealer.
NOTE For further problems not listed in the table, contact an au-
thorised service centre immediately.