17
EN
ENGLISH
(Translation of the Original Instructions)
See g. (15). To adjust the cutting height see
heading 6.9.
If the grass is long and needs cutting back signi-
cantly, cut twice using two dierent cutting heights.
Do not use the lowest cutting heights if the lawn
surface is uneven.
This would entail a risk of the cutting devices being
damaged against the surface and the lawn’s top
layer of soil being removed.
8.2 MOWING TIPS
To get the best mowing results, follow the tips
given below.
• Cut grass frequently.
• Run the machine at full revs.
• Grass should not be wet.
• Only use sharp cutting devices.
• Keep the bottom side of the cutting device
clean.
9 MAINTENANCE
9.1 ASSISTANCE PROGRAMME
To keep the machine in good working order in terms
of reliability, safety and environmental protection,
always adhere to the GGP servicing programme.
The points of intervention for this programme are
illustrated in the attached GGP maintenance ma-
nual.
The Basic Service must always be carried out by
an authorized service workshop.
All assistance interventions not listed
in this chapter must be carried out
assistance centre.
The checks carried out by an authorized service
workshop guarantee professional workmanship
and the use of genuine spare parts.
The handbook is stamped every time a Basic Ser-
vice is performed and each time an Intermediate
Service is carried out by an authorized service wor-
kshop. A handbook with these stamps increases
the second-hand value of the machine.
9.2 PREPARATION
All service and all maintenance checks must be
carried out on a stationary machine with the engine
switched o.
All service and all maintenance checks
must be carried out on a stationary ma-
the machine from moving.
Stop the engine.
9.3 MAINTENANCE TABLE
See chapter “13 MAINTENANCE SUM-
MARY TABLE”. The table is designed to
main operations to be performed and
the frequency of the same. Perform the
relative operation described based on
Change the oil more frequently if the
-
is high.
9.4 TYRE PRESSURE
Adjust the tyre pressure to meet the values provi-
ded in “0 TECHNICAL DATA TABLE”.
9.5 ENGINE OIL TOP-UP/CHANGE
9.5.1 Inspection / top-up (14)
check the level, make sure the machine
is on even ground.
For the type of oil to use please refer to “0 TECHNI-
CAL DATA TABLE”.
Open the cover (13:B).Wipe around the
dipstick. Unscrew it and pull it out. Wipe the
dipstick clean.
Push the dipstick down completely and
screw in place.
Now unscrew and pull the dipstick up again.
Read o the oil level.
Top up if the level is lower than the “FULL”
mark (14).
“FULL” mark. This results in the engine
“FULL” mark, the oil must be drained
until the correct level is achieved.
To Next Page
Loading...
Need help?
General
