19
EN
ENGLISH
(Translation of the Original Instructions)
For further information, please contact
your dealer.
To charge the battery connect the battery char-
ger to the side socket
(8:F).
9.8.3 AIR INTAKE
For the frequency of this intervention
see chapter 13.
See gure
(14:A). The engine is air-cooled. A blo-
cked cooling system can damage the engine.
9.9 LUBRICATION (
16)
For the frequency of this intervention
see chapter 13.
Action Fig.
Centre
point
Lubricate with oil at the
centre point.
16:A
Steering
chains
Brush the chains clean with
a wire brush.
Lubricate with universal
chain spray.
-
Steering
pulleys
Lubricate the pulley pins
with oil.
16:B
Te n -
sioning
arms
Lubricate the support points
with oil when each control is
activated.
Ideally this operation should
be carried out by two
people.
16:C
Control
cables
Lubricate the cable ends
with oil when each control is
activated.
This operation must be
carried out by two people.
16:D
Front
wheel
axle.
Remove the wheels and
handles of the quick con-
nectors.
Lubricate the axles with
grease.
16:E
9.10 CUTTING-MEANS ASSY
For maintenance operations on the cutting means
assembly, please refer to the instructions provided
in the relative manual.
10 ASSISTANCE AND REPAIRS
This manual provides all the necessary informa-
tion to run the machine and for correct basic main-
tenance operations which can be performed by
the user. Any regulations and maintenance opera-
tions not described herein must be carried out by
your Dealer or Authorized Service Centre, which
have the necessary knowledge and equipment
to ensure that the work is carried out correctly,
maintaining the correct degree of safety and the
original operating conditions of the machine.
Before performing any servicing ope-
rations:
a.
b. Apply the parking brake.
c.
d. Remove the key from the ignition.
Authorized service workshops carry out gua-
ranteed repairs and maintenance. Always use
genuine spare parts.
Genuine GGP spare parts and acces-
for GGP machines. Please remember
that non-genuine spare parts and ac-
-
proved by GGP.
The use of non-genuine spare parts and
-
chine operation and safety. GGP shall
or damages caused by such parts.
Genuine spare parts are supplied by
dealers.
It is advisable to send your machine
once a year to an authorized service
safety device inspection.
To Next Page
Loading...
Need help?
General
