0458-833-8221-A
27
English
16 During Operation
► Release the trigger switch.
The trimmer should switch off.
If the cutting attachment does not stop after you release
the trigger switch, remove the battery and take the trimmer
to an authorized STIHL servicing dealer to be repaired
before use.
16.1 Using the Trimmer
WARNING
To avoid serious or fatal injury, avoid contact with the
moving cutting attachment, @ 5.6.4.
WARNING
To reduce the risk of personal injury, never work with the
trimmer in wet or damp conditions, @ 5.5. Always wear
proper clothing and protective apparel, including proper eye
protection, when operating your trimmer, @ 5.4. Keep
bystanders at least 50 ft. (15 m) away from the work area,
@ 5.6.4. Work carefully and maintain proper control of the
trimmer, @ 5.6.2.
The trimmer is designed for two-handed operation.
► Swing the trimmer back and forth carefully in a controlled
arc parallel to the ground.
► Move forward slowly, keeping two hands on the trimmer at
all times.
When trimming, a bump guard (1) limits the cutting range of
the mowing line and helps prevent unwanted damage to
vegetation in certain circumstances (see illustration).
Always remove the battery before mounting or adjusting the
bump guard.
Observe all applicable laws, regulations, standards and
ordinances.
16.2 Adjusting the Nylon Line
WARNING
To reduce the risk of personal injury from unintended
activation, always switch off the motor and remove the
battery before manually adding or adjusting the nylon line.
► While pressing the trigger switch, tap the rotating mowing
head on the ground.
Approximately 1.2 in. (30 mm) of fresh nylon line will be
advanced with each tap.
The line limiting blade in the deflector trims the mowing line
to the proper length.
The bump feed mechanism will not advance additional line
if the mowing line is shorter than 0.1 in. (25 mm). To feed
additional line manually:
► Switch off the trimmer and remove the battery.
► Depress and hold the button on the mowing head.
► Pull out the mowing line by hand.
► If the mowing line cannot be pulled out to the required
length, install a new spool of line.
STIHL recommends keeping nylon line or polymer blades in
a water bath for at least 12 to 24 hours before use to
increase their useful life.
16 During Operation
To Next Page
Loading...
Need help?
General
Weight and Dimensions
