38 MS 210, MS 230, MS 250
: Push baffle plate (1) in direction
of fanwheel and carefully pull out
the ignition lead (2).
– Place the module in position,
insert the screws but do not
tighten them down yet.
: Secure ground wire (1) with outer
screw.
: Slide the setting gauge (2)
1111 890 6400 between the arms
of the ignition module and the
flywheel magnet poles.
– Press the ignition module against
the setting gauge and tighten
down the mounting screws to
4 Nm (3 lbf.ft).
Reassemble all other parts in the
reverse sequence.
Removing the flywheel:
– Fit the locking strip to block the
piston – b 5.3.
– Remove the fan housing –
b 8.2.
VA
135RA116
– Unscrew the flywheel nut.
– Pull off the flywheel.
If the flywheel cannot be removed
by hand, screw on the puller (1)
1116 893 0800 and tap its end to
release the flywheel. Remove the
puller.
VA
135RA117
1
Inspect flywheel (1) and magnet
poles (2) for cracks or other
damage. If you find any damage,
install a new flywheel.
Installing the flywheel:
Degrease crankshaft stub and bore
in flywheel with STIHL cleaner –
b 13.
– Fit the flywheel.
Check position of slot.
Assemble all other parts parts in the
reverse sequence.
– Tighten the flywheel nut to 28 Nm
(20.6 lbf.ft).
7.5 Flywheel
To Next Page
Loading...
Need help?
General
