Stihl RE 661 User Manual

RE 661, RE 661 PLUS, RE 961 PLUS
English
45
Disconnect the high-pressure hose
N Release the brake (1) on the hose
reel
To release the hose reel brake, pull the
lever (1) downward.
To lock the brake, press the lever (1)
firmly upward until the hose reel is
locked.
N Unroll the high-pressure hose (2)
N Unscrew the union nut (3)
N Open the hose guide (4)
N Pull high-pressure hose (2) off of
connector
Connecting the high-pressure hose
N Push the high-pressure hose (2)
onto the connector of the hose reel
N Attach union nut (3) and screw it on
and tighten by hand
N Push the high-pressure hose into
the hose guide (4) and close the
hose guide.
N Release the brake (1) on the hose
reel
N Wind up the high-pressure hose (2)
High-pressure hose and spray gun
Connection
N Push the high-pressure hose (1)
onto the connector (2)
N Attach union nut (3) and screw it on
and tighten by hand
Disconnection
N Push the coupling (4) in the
direction of the arrow and hold it
N Loosen the union nut (3) and
unscrew it from the connector in the
direction of the arrow
Briefly rinse out the water hose before
connecting it to the machine to prevent
sand and other particles from entering
the machine.
N Connect hose (3/4" diameter)
N Mesh the jaws with each other and
turn right as far as possible
N Turn on the tap – water tank fills with
water
4
2
3
1
676BA037 KN
1
2
3
647BA022 KN
647BA023 KN
3
4
Connecting the water
supply
Do not use dirty water. When the
water quality is poor (e. g., flowing
sand), use a water filter in the
water intake – see "Special
accessories".

Stihl RE 661 Specifications

General

Brand	Stihl
Model	RE 661
Category	Pressure Washer
Language	English