Name: Stryker CrossFlow
Brand: Stryker
Rating: 5 (1 reviews)

To Next Page

To Previous Page

EN-33

DRAFT

5� Follow these steps in reverse for assembly�

• Push in the the fuse drawer until it clicks into place�

• Turn the global fuse holders in a clockwise direction until they are fully pushed in and secure in their

original position�

Perform Annual Inspection

Stryker recommends inspections of the system on an annual basis� These inspections evaluate whether the

product currently or in the near future may fail in a manner that aects device performance�

Safety Test

Visually inspect the device and its components to ensure the:

• fuses correspond with the specications on the pump,

• labels and device markings are legible,

• mechanical condition of the system (wires, hardware, etc�) allows for its safe use, and

• the system is clean for safe and proper use�

Basic Function Test

Perform a basic function test to analyze the features, displays, and performance of the system�

1� Power

• Power on the pump according to the instructions in “Power the CrossFlow Pump On and O” section

of this manual� The power button will be illuminated by a green LED, indicating the system has

powered on�

2� Stepper motor

• Insert the cassettes according to the instructions in “Insert the Inow/Outow Cassette” section of

this manual�

• Visually inspect the stepper motors located in the cassette holder; they will be disengaged�

• Remove air from the inow tubing according to the instructions in “Prime the Inow Tubing” section

of this manual�

• Visually inspect the stepper motors; two motors will be engaged�

• Stop the pump�

• Visually inspect the stepper motors; they will be disengaged�

• Remove the cassettes according to the instructions in “Remove the Cassettes” section of this manual�

3� Device Detection

• Connect the components (for example, the hand control, footswitch, CrossFire system, etc�)

according to the instructions in “Connect the Components” section of this manual�

• Ensure the console displays the icon in the bottom of the screen of each component that is

connected when the device is powered on�

4� Pressure Sensor

Stryker CrossFlow Service Manual

Other manuals for Stryker CrossFlow