NOTE
When the control dial is turned fully
upward, the illumination brightness
becomes the maximum and the auto-
matic dimming function does not work
at all.
Headlight beam leveler
(WRX STI)
The WRX STI version has High-Intensity
Discharge (HID) headlights on the low
beam setting. The HID headlights gener-
ate more light than conventional halogen
headlights. Therefore a driver of an
oncoming vehicle may experience too
much glare when your headlight beam
height adjustment is high due to the
vehicle carrying a heavy load.
The headlight beam leveler can be used
to adjust beam height to avoid such a
condition.
The higher the number the knob is turned
to, the lower the beam becomes.
Front fog light switch (if
equipped)
The front fog lights operate only when the
light switch is in the “
” position.
However, the front fog lights turn off when
the headlights are switched to high beam.
To turn on the front fog lights, turn the front
fog light switch on the turn signal lever
upward to the “
” position. To turn off the
front fog lights, turn the switch back down
to the “OFF” position.
Instruments and controls 3-37
– CONTINUED –
To Next Page
Loading...
Need help?
General
