Wattage Bulb No.
1) High beam headlight 12V-60W 9005 (HB3)
2)
Low beam headlight (except WRX STI)
Low beam headlight (WRX STI)
12V-55W
12V-35W
H11
D2S
3)
Front turn signal/Front side marker light 12V-27/8W 1157NA
4)
Map light 12V-8W –
5)
Dome light 12V-8W –
6)
Front fog light 12V-51W 9006 (HB4)
7)
Trunk room light (4-door) 12V-5W (W5W)
8)
High mount stop light (4-door, if equipped) 12V-21W (P21W)
9)
Rear turn signal light (4-door) 12V-21W (WY21W)
10)
Back-up light (4-door) 12V-16W 921
11) Brake/tail and rear side marker light (4-door) 12V-21/5W 7443
(W21/5W)
12)
Cargo area light (5-door) 12V-5W –
13)
Rear side marker light (5-door) 12V-5W 168
14)
Rear turn signal light (5-door) 12V-21W (WY21W)
15)
Back-up light (5-door) 12V-21W 7440
16)
Licence plate light 12V-5W 168 (W5W)
A)
High mount stop light (5-door) ––
B)
Brake/tail light (5-door) ––
C)
High mount stop light (4-door, if equipped) –
–
CAUTION
Replace any bulb only with a new
bulb of the specified wattage. Using
a bulb of different wattage could
result in a fire.
& Headlights (WRX STI)
WARNING
High-intensity-discharge (HID) bulbs
are used for the low beams of the
headlights. These HID bulbs use an
extremely high voltage. To avoid the
risk of an electric shock and result-
ing serious injury, you should not
attempt to replace them. Neither
should you attempt to replace the
high-beam bulbs, remove/refit the
headlight assemblies, or remove
any headlight-assembly compo-
nents. For replacement of the head-
light bulbs (low-beam and high-
beam), removal and installation of
the headlight assemblies, and re-
moval of headlight-assembly com-
ponents, contact your SUBARU
dealer.
Maintenance and service 11-49
– CONTINUED –
To Next Page
Loading...
Need help?
General
