5-8 FUEL SYSTEM
9. Remove the high pressure fuel pump 1 and the grommet
2 from the separator cover and then disconnect the pump
lead wire connector.
INSPECTION
NOTE:
If cracks, excessive wear or other damage is found on any com-
ponent, replace component.
Needle valve/Valve seat
Inspect the needle valve and the valve seat for groove, other dam-
age or dirt.
Replace or clean if necessary.
Float
Inspect the float for crack or other damage.
Replace if necessary.
Filter
Inspect the pump suction filter for clog or other damage.
Replace or clean if necessary.
To Next Page
Loading...
Need help?
General
