8-10 POWER TRIM AND TILT
PTT MOTOR
See the PTT MOTOR INSTALLATION section on the page 8-
14.
AIR BLEEDING
• Pour the recommended PTT fluid in to the reservoir until the
specified level.
• Perform the air bleeding procedure.
See the AIR BLEEDING section on the page 8-3.
PTT MOTOR
PTT MOTOR REMOVAL
NOTE:
Before removing the PTT motor, wash the PTT body with a stiff
bristle brush and hot, soapy water to remove sand or dirt and
dry the PTT body with compressed air.
1. Place the lower mounting eye of the PTT cylinder in a vise.
Tighten the vise only enough to secure the PTT unit, do
not over tighten.
NOTE:
To prevent damage to the PTT cylinder use wood blocks, vise
jaw protectors, etc., between the vise jaws and the PTT com-
ponents before tightening the vise.
2. Remove the four bolts securing the PTT motor to the PTT
pump case.
3. Detach the PTT motor from the PTT pump case.
Note the position of the drive joint 1 and the O-ring 2 and
remove them.
To Next Page
Loading...
Need help?
General
