DRIVE TRAIN 4-11
REAR AXLE
Inspect the splines of the rear axle and splines of the ring gear
for wear or damage.
If any wear or damage is found, replace the rear axle and ring
gear with the new ones.
 Check the axle shaft runout. (!7-61)
REAR DRIVE REASSEMBLY
Reassemble the rear drive in the reverse order of disassembly.
Pay attention to the following points:
NOTE:
Before reassembly, thoroughly clean all parts in cleaning sol-
vent.
FINAL GEAR CASE OIL SEAL
 Install new oil seals into the gear case and case cover with
the special tool.
 Apply SUZUKI SUPER GREASE to the new oil seal lips.
" 09913-70210: Bearing installer set
$ 99000-25030: SUZUKI SUPER GREASE îš“ Aîš” ( USA)
99000-25010: SUZUKI SUPER GREASE îš“ Aîš” ( Others)
NOTE:
The marked side of the oil seal should be positioned outside.
(!4-21)
PartShark.com
877-999-5686
To Next Page
Loading...
Need help?
General
