8-16 ELECTRICAL SYSTEM
Apply 12 V to the terminals and check for continuity between the
positive and negative terminals using the multi circuit tester. If
the starter relay clicks and continuity is found, the relay is OK.
$ 09900-25008: Multi circuit tester set
, Tester knob indication: Continuity test (-)
"
Measure the relay coil resistance between the terminals using
the multi circuit tester. If the resistance is not within the specified
value, replace the starter relay with a new one.
# Starter relay resistance
Standard: 3  6 Ω
ΩΩ
Ω
$ 09900-25008: Multi circuit tester set
) Tester knob indication: Resistance (Ω
ΩΩ
Ω)
NEUTRAL RELAY INSPECTION
 Remove the neutral relay.
First check the insulation between
A and
B terminals with the
tester. Then apply 12 V to terminals as shown and check the
continuity between
A and
B. If there is no continuity, replace
the neutral relay with a new one.
$ 09900-25008: Multi circuit tester set
, Tester knob indication: Continuity set (-)
PARKING BRAKE SWITCH
(!8-26)
Do not apply a battery voltage to the starter relay for
more than five seconds.
This may overheat and damage the relay coil.
PartShark.com
877-999-5686
To Next Page
Loading...
Need help?
General
