SERVICES
60
WATER TANKS
• Ensure that the tank drain valve (which is a
Yellow handled valve identical in appearance
to the water heater drain valve) is in the
closed position - with the handle horizontal.
• Rotate the handle of the White selector valve
clockwise to select internal tank as the water
source.
• Press the 'tank fill' button on the control
panel to transfer water from the external
container to the internal tank.
• Water will now be transferred from the
external container to the internal water tank.
The amount of water within the internal tank
can be checked by looking at the water level
gauge on the control panel.
• Once the control panel shows this level at ¼
or higher, taps can be used as normal.
• Press the 'water pump' button to switch on
the internal pump.
• When the control panel display shows the
internal tank as full, or the external container
is empty.
• Press the 'Tank Fill' button to switch off the
external pump. Refill the external container
if required.
To use the caravan with a mains
water connection:
• When using a mains water connection the
pump will still need to be switched on to
supply water to the water heater, taps
and shower.
• If a mains water connection is used, please
ensure this is a Truma Waterline connection,
which has a built in pressure reducing valve.
• The Waterline connection should be
connected to the lower connection point on
the outside of the caravan, labelled as ‘direct
to taps’.
Plumbing Connections
In most cases, speed fittings are used,
which allow easy and quick connection of
water pipes.
To connect a pipe to a fitting, simply push the
pipe into the connector. To remove the pipe,
push the collar of the fitting inwards, and then
withdraw the pipe.
To connect a pipe, simply push the pipe into
the connector.
To remove a pipe, push the collar inwards, and
then remove the pipe.
As a note, when refitting the pipe, ensure
the end of the pipe is round (not oval) and
the cut is square. If not, it could lead to
water leaks.
To Next Page
Loading...
Need help?
General