3.6
Introduction To Servicing
M2000-00
30/12/97 Copyright TEL
3.2.3 To Detach The Control Head
3.2.3.1 Locally Mounted Models
Remove all covers, as instructed in Section 3.2.2.
Unplug the loom running between the control head and the logic PCB.
Note:
In EMC model radios, the loom connects to a Micromatch connector on the
EMC filter PCB (refer to Section 3.2.5).
3.2.3.2 Remotely Mounted Models
Remove the four screws on the front of the radio dummy front panel. This will
give access to the control head loom, which can now be unplugged.
Note:
In EMC model radios, the loom connects to a Micromatch connector on the
EMC filter PCB (refer to Section 3.2.5).
To Next Page
Loading...
Need help?
General
