17
2 MANUAL INSTALLATION
DMS-CTC-20111123-0002 v1.0
2 Manual Installation
Installation
This chapter will help you to manually install your MediaAccess Gateway.
Setting up your network
Proceed as follows:
1 Connect your MediaAccess Gateway to your service provider’s network.
For more information, see “2.1 Connecting the MediaAccess Gateway to your Service Provider’s Network” on page 18.
2 Power on the MediaAccess Gateway.
For more information, see “2.2 Powering on the MediaAccess Gateway” on page 19.
3 Connect your computer to the MediaAccess Gateway.
For more information, see “2.3 Connecting Your Network Devices to the MediaAccess Gateway” on page 20.
4 Configure your MediaAccess Gateway.
For more information, see “2.4 Configure the MediaAccess Gateway” on page 21.
5 Share your content or media on your local network, continue with “5 Sharing Content” on page 53.
6 If you purchased the mobile USB adapter, setup the 3G backup connection.
For more information, see “2.5 Setting Up the 3G Fall-Back WAN Connection” on page 22.
7 Once you successfully installed your MediaAccess Gateway, it is recommend to backup your configuration. This will
allows you to return to this configuration when needed (for example, after misconfiguration). For more information, see
“3.2 Backing Up/Restoring your Configuration” on page 38.
To Next Page
Loading...
Need help?
General
