56
(Continued)
Network
Cannot connect to the network.
• Confirm the network connection and settings.
(⇒ 21)
• If the network is set to be invisible, make the
network visible while you set up the network for
this unit or make a wired LAN connection.
To switch the Wi-Fi function between “On” and
“Off”, press and hold the volume [
] on the top
while pressing [•DIMMER / -INFO] on the rear of
this unit for approx. 5 seconds.
• This system’s Wi-Fi security supports WPA2™.
Your wireless router must therefore be WPA2™
compatible. For details on the security supported
by your router and how to change the settings,
please refer to the operating instructions or
contact your internet service provider.
• Make sure that the multicast function on the
wireless router is enabled.
• Depending on the router, WPS button may not
work. Try another connection method. (⇒ 25)
• The wireless LAN environment or radio
interference in your area may cause connection
problem. In this case, try another connection
method. If the problem persists, make a wired
LAN connection. (⇒ 22)
• While the AC mains lead is disconnected, the LAN
cable must be connected or disconnected.
Cannot select this system as the output
speakers.
• Make sure that the devices are connected to the
same network as this unit.
• Reconnect the devices to the network.
• Turn the wireless router off and then on.
• Turn this unit to standby and on, and then select
this system as the output speakers again.
Cannot select this unit from the Chromecast-
enabled apps.
• When using the Chromecast-enabled apps to play
music on this unit, you need to set up a network
connection using “Google Home” app. (⇒ 27)
• You may not select this unit from the video apps,
etc.
To Next Page
Loading...
Need help?
General
