31
4
Service
LIST OF ILLUSTRATIONS
(cont)
Hyperlinked Page
-
Scroll UP or Down
-
Left click to select
Location of Screws on Power Supply Section
4-9
Location of Screws Holding Storage Circuit Board to Module
4-9
Location of Screws Holding Horizontal Circuit Board to Module
Assembly 4-1 0
Location of Interconnecting and Ground Leads Between Attenuator
and Vertical Circuit Boards
4-1 1
Location of Screws Holding Attenuator Circuit Board to Chassis 4-11
Location of Delay Line Leads
4-1 1
Location of Screws and Spacers Holding Trigger Circuit Board 4-12
Idealized Display of Risetime 5-8
Calibration Shield in place on 314
5-26
Typical display of correct adjustment of
C1 or C11
5-26
Display of correct high-frequency compensation (idealized)
5-27
Typical display of external
XI0 attenuator compensation (idealized) 5-29
Semiconductor Lead Configurations
Circuit Board Locations
Adjustment Locations
Adjustment Locations
Adjustment Locations
Adjustment Locations
Al-Attenuator Board
A2-Vertical Amplifier Circuit Board
A3-Trigger Switch Circuit Board
A4-Horizontal Circuit Board
A5-Storage Circuit Board
A7-Power Supply Circuit Board
A8-Interface Circuit Board
A6-H V and Unblanking Circuit Board
AS-Intensity Limit Circuit Board
LIST OF TABLES
Table
No.
1-1 Characteristics
2-1 Power Cord color codes
3-1 Sweep Generator IC Input-Output
4-1 Voltage and Ripple Tolerances
5-1 Test Equipment
5-2
Volts/Div Accuracy
5-3 Time/Div Accuracy (unmagnified)
5-4 Time/Div Accuracy (magnified)
5-5 Trigger Levels
5-6
Volts/Div Compensation
Page
1-1
Hyperlinked Page
-
Scroll UP or Down
-
Left click to select
REV. B,
FEB.
1976
To Next Page
Loading...
Need help?
General
