AFG1000 Series Quick Start User Manual
Instrument front panel, interface, and rear panel
Select run mode
Push the Mod panel button, and then press one of the four Run Mode bezel
buttons to select the instrument signal output method. Modulation,
sweeping, and burst modes are only available in Ch1on the AFG1022.
1.
The default Run Mode
is Continuous.
2.
To select a modulated
waveform, press Mod.
3.
To select a sweep
waveform, press
Sweep.
See page 35 for
details on
sweeping
waveforms.
4.
To select a burst
waveform, press
Burst.
To Next Page
Loading...
Need help?
General
