AFG1000 Series Quick Start User Manual
USB memory device
A USB memory connector, located on the front panel of the instrument, allows
you to perform the following tasks:
Save user-defined waveforms to a USB memory device (See
page 30,
Create/save a user-defined waveform.) or recall waveform from a USB
memory device (See
page 32, Recall a user-defined waveform.)
Save or recall instrument setups to/from files on a USB memory device (See
page 52, Save/recall instrument setup.)
Update your instrument firmware (See page 10, Update your instrument
firmware.)
CAUTION. To prevent data loss or damage to the USB memory device, do not
remove the USB memory device during the process of reading and writing data.
USB connector
requirements
This instrument supports a USB memory device with a FAT32 or FAT16 file
system. If the USB memory device doesn't work properly, format it into the
FAT32 or FAT16 format and try again; or try another USB memory device.
Emissions can exceed the specification limit if a USB cable is placed in the
front-panel USB memory connector. Use only appropriate USB memory devices.
To Next Page
Loading...
Need help?
General
