Getting started
Protect your DUT
Use care when you connect the instrument Channel Output to your DUT (device
under test). To avoid damage to your DUT, the following preventive measures are
provided. Follow these steps to set the limit values for high level and low level.
1. Push the front-panel Top
Menu button. The Output
Menu is disp
layed at the
bottom of the bezel menu.
Select Output Menu.
2. In this exa
mple, High
Limit is s et to 5.000 V,
and Low Limit is set to
-5.000 V.
3. Push the Limit bezel
button.
4. Select Hi
gh Limit. Use
numeric keys or the
general purpose knob to
enter a v
alue.
Enter 50 mV for High
Limit, and -50 mV for Low
Limit.
5. Push th
e front-panel
Sine button to display
the waveform parameter.
Confir
m that High and
Low voltage levels were
changed.
You ca
nnot enter any
values greater than
50 mV for High level.
NOTE. When you set limit values using Output Menu, a level indicator is
dis
played at left end of graph area.
AFG3000 and AFG3000C Series User Manual 15
To Next Page
Loading...
Need help?
General