Troubleshooting
Table 4-7: Calibration error codes (cont.)
Error code Error log message
Possible defect
on board Note
260000025
Acoefficient is not also 5 or 6.(tek15_ch1_k) AWG12G AWG12G: U300A
260000026
Acoefficient is not also 5 or 6.(tek15_ch2_k) AWG12G AWG12G: U300B
260000027
The Cal value is not found.(tek15_ch1_ng_f) AWG12G AWG12G: U300A
260000028
The Cal value is not found.(tek15_ch2_ng_f) AWG12G AWG12G: U300B
260000029
Temperature changed 5 degrees or more.(@Magic Cal.)
260000121
The difference of tek15_ch1_timing_1 and
tek15_ch2_timing_1 is larger than 150ps.
AWG12G AWG12G: U300
260000123
The difference of tek15_ch1_timing_2 and
tek15_ch2_timing_2 is larger than 150ps.
AWG12G AWG12G: U300
260000125 tek15_ch1_k and tek15_ch2_k are not equal.
AWG12G AWG12G: U300
260001009
Invalid NG Areas.(ch1@Magic Cal.) AWG12G AWG12G: U300xA
260001010
Invalid NG Areas.(ch2@Magic Cal.) AWG12G AWG12G: U300xB
261000001
The C al value is not found.
(ch1_ram_address_timing_1@12GHz)
AWG12G AWG12G:U400A, U500A , U510A
261000002
The C al value is not found.
(ch2_ram_address_timing_1@12GHz)
AWG12G AWG12G:U400B, U500B , U510B
261000003
The C al value is not found.
(ch1_ram_address_timing_1@10GHz)
AWG12G AWG12G:U400A, U500A , U510A
261000004
The C al value is not found.
(ch2_ram_address_timing_1@10GHz)
AWG12G AWG12G:U400B, U500B , U510B
261000005
The C al value is not found.
(ch1_ram_data_timing_1@12GHz)
AWG12G AWG12G:U400A, U500A , U510A
261000006
The C al value is not found.
(ch2_ram_data_timing_1@12GHz)
AWG12G AWG12G:U400B, U500B , U510B
261000007
The C al value is not found.
(ch1_ram_data_timing_2@10GHz)
AWG12G AWG12G:U400A, U500A , U510A
261000008
The Cal value is not
found.(ch2_ram_data_timing_2@10GHz)
AWG12G AWG12G:U400B, U500B , U510B
261000101
The difference of ch1_ram_address_timing_1 and
ch2_ram_address_timing_1 is larger than 48.(@12GHz)
AWG12G AWG12G:U400A/B, U500A/B,
U510A/B
261000103
The difference of ch1_ram_address_timing_2 and
ch2_ram_address_timing_2 is larger than 48.(@10GHz)
AWG12G AWG12G:U400A/B, U500A/B,
U510A/B
261000105
The difference of ch1_ram_data_timing_1 and
ch2_ram_data_timing_1 is larger than 48.(@ 12GHz)
AWG12G AWG12G:U400A/B, U500A/B,
U510A/B
261000107
The difference of ch1_ram_data_timing_2 and
ch2_ram_data_timing_2 is larger than 48.(@ 10GHz)
AWG12G AWG12G:U400A/B, U500A/B,
U510A/B
261000108
The difference of ch1_ram_data_timing_1 -
ch1_ram_data_timing_2 is larger than 48.
AWG12G AWG12G:U400A/B, U500A/B,
U510A/B
261000109
The difference of ch2_ram_data_timing_1 -
ch2_ram_data_timing_2 is larger than 48.
AWG12G AWG12G:U400A/B, U500A/B,
U510A/B
4–68 AWG7000B and AWG7000C Series Service Manual
To Next Page
Loading...
Need help?
General
