Compliance Information
This section lists the EMC (electromagnetic compliance), safety, and environmental
standards with which the instrument complies.
EMC Compliance
EC Declaration
of
Conformity-EMC
Meets intent
of
Directive
2004
/
108IEC
for Electromagnetic Compatibility. Compliance was
demonstrated to the following specifications as listed
in
the Official Journal
of
the European
Communities:
EN
61326-1 2006, EN 61326-2 2006.
EMC
requirements for electrical equipment for
measurement, control, and laboratory use.
1,
2. 3
•
CISPR
11
:2003. Radiated and conducted emissions, Group
1,
Class A
• IEC 61000-4-2:200
l.
Electrostatic discharge immunity
• IEC 61000-4-3:2002. RF electromagnetic field immunity 4
•
-
• IEC 61000-4-4:2004. Electrical fast transientlburst immunity
• IEC 61000-4-5:200l. Power line surge immunity
• IEC 61000-4-6:2003. Conducted RF immunity 5
• IEC 61000-4-11:2004. Voltage dips and interruptions immunity 6, 7
EN
61000-3-2:2006. AC power line harmonic emissions.
EN
61000-3-3:1995. Voltage changes, fluctuations, and flicker.
European
Contact.
Tektronix UK, Ltd.
Western Peninsula
Western Road
Bracknell, RG
12
lRF
j
United Kingdom
This product
is
intended
for
use
in
nonresidential areas only, Use
in
residential areas may cause electromagnetic
interference,
Emissions which exceed the
lev
els required
by
this standard
may
occur when this equipment
is
cormected
to
a test
object.
To
ensure compliance with the EMC standards listed here, high quality shielded interface cables should
be
used.
The tolerance
of
the 100uADC, I
OmADC
ranges while subjected
to
the test
field
(3
Vim over
the
frequency range
of80
MHz
to
I
GH
z,
1.4
GHz
to
2.0
GH
z,
and
IVim
from
2.0 GHz
to
2.7 GHz, with
80
% amplitude modulation
at
I kHz) can increase
by
+1- (0.
06
%
of
range) over the frequency range
of
1.7
- 1.9GHz. (IEC 61000-4-3),
The tolerance
of
the 100uADC, 10mADC ranges
wh
i
Ie
subjected
to
the injected test signal
(3
V
rms
over the
frequency range
of
150
kHz
to
80
MHz, with
80
% amplitude modulation
at
I kHz) can increase
by
+1
- (0.08%
of
range)
at
the
frequency range
of20
- 50MHz. (lEC 61000-4-6).
6
Performance Criterion C applied
at
the
70
%/
25
cycle Voltage-Dip and the 0
0/01
250 cycle Voltage-Interruption test
levels (IEC 61000-4-11).
Instrument rebooting may
be
experienced where the EUT takes approximately
18
seconds
to
recover
from
IEC
61000-4-11 transient immunity test.
7
To Next Page
Loading...
Need help?
General
