EasyManuals Logo
Home>Tektronix>Multimeter>DMM4020

Tektronix DMM4020 Safety And Installation Instructions

Tektronix DMM4020
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
DMM4040
and
4050
Safety and Installation Instructions
Australia / New Zealand Declaration
of
Conformity - EMC
Complies with the
EMC
provision
of
the Radioconununications Act per the following
standard,
in
accordance with ACMA:
CISPR
11
:2003. Radiated and Conducted Emissions,
Group
I,
Class A,
in
accordance
with
EN
61326-1 :2006 and EN 61326-2-1 :2006.
Safety
Compliance
EC Declaration
of
Conformity - Low Voltage
Compliance was demonstrated
to
the following specification as listed
in
the Official
Journal
of
the European Communities:
Low Voltage Directive
2006
/
95
/
EC.
EN
61010-1: 2001. Safety requirements for electrical equipment for
measurement control and laboratory use.
u.s
Nationally Recognized Testing Laboratory Listing
ISA-82.02.01. Safety Standard for Electrical and Electronic Test,
Measuring
,
Controlling and Related Equipment -- General Requirements.
Canadian Certification
CAN/CSA-C22.2
No. 61010-1:2004. Safety requirements for electrical
equipment for measurement, control, and laboratory use.
Part
I.
Additional Compliances
IEC
61010-1: 2001. Safety requirements for electrical equipment for
measurement, control, and laboratory use.
ANSllUL
61010-1:2004,
2nd
Edition.
Standard for electrical measuring and
test equipment.
Equipment Type
Test and measuring.
Safety Class
Class I - grounded product.
Pollution Degree Description
A measure
of
the contaminants that could
occur
in the environment around and within a
product. Typically the i.nternal
environment
inside a product
is
considered to be the
same
as the external. Products should be used only
in
the environment for which they are rated.
Pollution Degree
I.
No
pollution or only dry, nonconductive pollution occurs.
Products in this category are generally encapsulated, hermetically sealed, or
located in clean rooms.
Pollution Degree 2. Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by condensation must be
expected. This location
is
a typical officelhome environment.
Temporary
condensation occurs only when the product is out
of
service.
8

Table of Contents

Other manuals for Tektronix DMM4020

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Tektronix DMM4020 and is the answer not in the manual?

Tektronix DMM4020 Specifications

General IconGeneral
BrandTektronix
ModelDMM4020
CategoryMultimeter
LanguageEnglish

Related product manuals