Application Exa
mples
Cleaning
Use these procedures to clean your instrument. If additional cleaning is required, have your instrument serviced by qualified
service personnel.
Exterior Cleaning
Clean the ex
terior surfaces of the chassis w ith a dry lint-free cloth or a soft bristle brush. If any dirt remains, use a cloth or
swab dipped in a 75% isopropyl alcohol solution. Use a swab to clean narrow spaces around controls and connectors. Do
not use abrasive compounds on any part of the chassis.
Clean the On/Standby switch using a dampened cleaning towel. Do not spray or wet the switch directly.
CAUTION. I
mproper cleaning agents, methods, or excessive force can damage the instrument. Do not use chemical
cleaning agents that might damage the plastics used in this oscilloscope. Use only deionized water when cleaning the
front-panel buttons. Use a 75% isopropyl alcohol solution as a cleaner and rinse with deionized w ater. Before using any
other typ
e of cleaner, consult your Tektronix Service Center or representative.
To preven
t getting moisture inside the instrument during external cleaning, use only enough liquid to dampen the cloth
or applicator.
DPO7000 Series and DPO/DSA70000/B Series Quick Start User Manual 137
To Next Page
Loading...
Need help?
General
