Commands Listed in Alphabetical Order
Unit string Description
"hr" hours
"joules" joules
"min" minutes
"ohms" ohms
"percent"
percent
"pulses" pulses
"s" seconds
"unk" unknown
Examples
MEASUREMENT:IMMED:UNITS? might return
:MEASUREMENT:IMMED:UNIts "s"
indicating that uni
ts for the immediate measurement are in seconds.
MEASUrement:IMMed:VALue? (Query Only)
Returns the value of the measurement specified by the MEASUrement:IMMed:
TYPe command. The measurement is immediately taken on the source(s)
specified by a MEASUrement:IMMed:SOUrce<x> command.
NOTE. A change to HORizontal:MAIn:SCALe or CH<x>:SCALe will not
necessarily ha
ve taken affect if immediately followed by this command.
NOTE. Before using this query, you should make sure the prerequisites are
completed. (S
ee page 3-7, Synchronization M ethods.)
Group
Measurement
Syntax
MEASUrement:IMMed:VALue?
Related Commands
MEASUrement:IMMed:TYPe,
MEASUrement:IMMed:SOUrce<x>,
*ESR?,
ALLEv?
2-430 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual
To Next Page
Loading...
Need help?
General
