Performance Ve ri fi cation
11. Set the Acquisi
tionmodetoSampleasfollows:
a. Push the front-panel Acquire button.
b. Push the Mode lower-bezel b utton (if it is not already selected).
c. Push the Sample side bezel button.
12. Repeat the tests at 50 Ω as follows:
a. Push the front-panel channel 1 button.
b. Set the Ter
mination (input impedance) to 50 Ω.
c. Push the front-panel Wave Inspector Measure button, and repeat steps 5
through 1
1.
13. Repeat the tests at 250 MHz bandwidth as follows:
a. Push the front-panel channel 1 button.
b. Set the Termination (input impedance) to 1MΩ.
c. Push the bottom-bezel Bandwidth button.
d. Push the side-bezel 250 MHz button.
e. Push t
he front-panel Waveform Inspector Measure button.
f. Repeat steps 5 through 12.
14. Repeat the tests at 20 MHz bandwidth as follows:
a. Push the front-panel channel 1 button.
b. Set the Termination (input impedance) to 1MΩ.
c. Push the bottom-bezel Bandwidth button.
d. Pu
sh the side-bezel 20 MHz button.
e. Push the front-panel Waveform Inspector Measure button.
f. Repeat steps 5 through 12.
15. Repeat the procedure for all remaining channels as follows:
a. Push the front-panel button to deselect the channel that you have already
tested.
b. Starting from step 3, repeat the procedure for each input channel.
MDO4000 Series Specifications and Performance Verification 77
To Next Page
Loading...
Need help?
General
