Tektronix TBS1072B User Manual

Autorange
When you hold the Autoset button for more than 1.5 seconds, the oscilloscope
activates or deactivates the Autorange function.
This function automatically adjusts setup values to track a signal. If the signal
changes, the setup continues to track the signal. When you power on the
oscilloscope, autoranging is always inactive.
Options Comment
Autoranging Activates or deactivates the Autorange function
Vertical and Horizontal Tracks and adjusts both axes
Vertical Only Tracks and adjusts the Vertical scale; does not change the horizontal
settings
Horizontal Only Tracks and adjusts the Horizontal scale; does not change the vertical
settings
Undo Autoranging Causes the oscilloscope to recall the previous setup
The following conditions cause autorange to adjust settings:
■
Too many or too few waveform periods for a clear display of the trigger
source (except when in Vertical Only)
■
Waveform amplitude too large or too small (except when in Horizontal Only)
■
Ideal trigger level changes
When you push the Autoset button for more than 1.5 seconds, the oscilloscope
enters the autorange mode and adjusts controls to produce a usable display of the
input signal.
Function Setting
Acquire mode Sample
Display format YT
Display persist Off
Horizontal position Adjusted
Horizontal view Main
Run/Stop RUN
Horizontal scale (seconds/division) Adjusted
Trigger coupling DC
Trigger holdoff Minimum
Trigger level Adjusted
Trigger mode Edge
Vertical bandwidth Full
Vertical BW limit Off
Vertical coupling DC
Reference
76 TBS1000B and TBS1000B-EDU Series Oscilloscopes User Manual

Tektronix TBS1072B Specifications

General

Brand	Tektronix
Model	TBS1072B
Category	Test Equipment
Language	English