Maintenance
TDS3000C Series S ervice Manual
4-35
Troubleshooting
This section contains information and procedures to help you isolate a defective
module in a TDS3000C series oscilloscope.
WARNING. Before doing this or any other procedure in this manual, read the
General Safety Summary and Service Safety Summary found at the beginning of
this manual. Also, to prevent possible injury to service personnel or damage to
electrical components, read Preventing ESD on page vii.
If you replace the main board, you must adjust the instrument after repair. R efer
to the chapter Adjustment Procedures for information about adjustment.
You need the the following equipment to troubleshoot the instrument.
Tools and Equipment Example
DMM 3.5 or greater digit DMM
Adjustment After Repair
Required Tools and
Equipment
To Next Page
Loading...
Need help?
General
