Tenda O3 User Manual

6
1.2 CCTV surveillance
To ensure the safety of employees and property, a video surveillance system needs to be installed
in a building site.
1.2.1 Solution
Tenda CPE can meet this demand.
O4 is used as an example to illustrate the installation procedures. Procedures for other CPEs are
similar.
1.2.2 Set up the CPEs
At least two CPEs are required for bridging.
Option 1: Automatic bridging (recommended)
 Automatic Bridging is only applicable when the CPEs are in factory settings.
 When performing peer-to-peer bridging, ensure that only two CPEs are powered on nearby.
Otherwise, the peer-to-peer bridging may fail.
 For peer-to-multiple peers bridging, perform peer-to-peer bridging first, and then power on the
rest CPEs within 30 minutes.
 A CPE can bridge to 15 CPEs at most.
Scenario 1: Peer-to-peer bridging
Step 1 Place the two CPEs next to each other, see the following figure.

Tenda O3 Specifications

General

5 GHz	No
2.4 GHz	Yes
Number of users	15 user(s)
Transmitting power	29 dBmW
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Receiver sensitivity	MCS0: -88dBm MCS7: -72dBm
Maximum outdoor range	5000 m
Maximum data transfer rate	150 Mbit/s
USB 2.0 ports quantity	0
Ethernet LAN (RJ-45) ports	1
Placement	Wall
Certification	FCC / CE / RoHS
Product color	White
LED indicators	LAN, Power, WAN
International Protection (IP) code	IP64
Antenna features	Integrated antenna
Antenna gain level (max)	12 dBi
Output current	1 A
Output voltage	12 V
Power consumption (max)	6 W
Security algorithms	WPA, WPA2, WPA2-PSK
Cables included	LAN (RJ-45)
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	-20 - 55 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	94.86 mm
Width	270 mm
Height	67.5 mm