TLD GPU-406 User Manual

Creation: 01.31 - 2014 2-4-2
GPU - 406
GPU - 409
Engine and Controls
PROBLEM
CAUSE
REMEDY
1. Engine will not start.
Starter will not crank engine.
A. Battery disconnect switch (S6)
or emergency stop switch (S22) is
open or defective.
A. Check for proper operation of
S6 and S22. 24VDC should be
passing through both switches.
B. Battery (BT1/BT2) is
discharged or a poor connection
exists on the battery.
B. Ensure that the voltage across
both batteries is approximately
24VDC. Ensure that 24VDC is
reaching the starter relay terminal
and ignition switch.
C. Defective F2 Fuse
C. Check the fuse and replace it if
the fuse has blown.
D. Defective GCM
D. With the GCM on and at the
start screen, press the blue button
to start the engine. A bar graph
should appear to indicate that the
engine cranking. Make sure that
the starter relay (K4) is closing.
Replace the GCM if this does not
occur.
E. Defective starter relay (K4)
E. Momentarily connect a jumper
wire between the terminals of the
starter relay (K4). If the starter
motor (M11) attempts to crank the
engine, it indicates that the starter
relay is defective. Replace the
starter relay (K4)
F. Defective starter motor (M11)
F. If the starter motor (M11) did
not operate in Remedy E, the
starter motor is defective, and it
should be replaced.
G. Internal seizure
G. If all engine starting
components are functioning
properly, and the starter motor is
unable to crank the engine,
internal seizure is indicated.
Contact the engine manufacturer
for repair.
Property of American Airlines

TLD GPU-406 Specifications

General

Brand	TLD
Model	GPU-406
Category	Portable Generator
Language	English