70
Route ID This is the Route Index. This is the route index. All matches are done
based on the longest prefix match first and then if the prefixes are the same on the Route Index.
Prefix This is the prefix that needs to be matched against the number. All
outbound calls are compared against the existing prefixes and then routed based on longest prefix match
and route index. If the Enable Route failover is checked, the system will try all available routes in
sequence until the call is successful or fails.
Route To This field displays the IP Address or the Domain Name of the terminating
SIP End Point. The filed may be an IP Address or a Domain Name or the keyword DEVICE. If the field is
the IP address of a SIP proxy server or SIP gateway, the system will automatically route and terminate the
call to it. If the keyword DEVICE is used the system will attempt to terminate the call via existing FXO
device line.
Translation This field allows automated number translations. Number Translation
allows conversion of a dialed number into another number to normalize it according to the termination
End Point that is selected. For example, a number may need some sort of country or area code
prefix before being sent out to the termination server. For more information about translation algorithms
please refer to Appendix T
Outbound Ring Timeout The device will terminate the call attempt if the call is not connected to
the called station within a predefined period of time in seconds. This timeout allows manageable route
failover procedure to ensure that all calls are timely connected to their destination. The Default
Outbound Ring Timeout is 30 seconds.
Enable Route Failover This selection allows route failover for all outbound calls. This route
failover is enabled, the device will attempt to reconnect to the number utilizing alternative routes that exist
in its routing table.
Enable Skype This selection will allow calls to be accepted from or send to the
Skype network. The Skype support requires Digital Media Center software to be installed on the
subscriber desktop. The Skype software should also be installed on the same desktop as the DMC
To Next Page
Loading...
Need help?
General