Select Usable Rainfall
USABLE RAINFALL
100%
2. 100% is selected by default. To decrease the value, turn the
Lower Line knob right.
1. Turn the Upper Line knob to display Usable Rainfall.
The Usable Rainfall setting defines the percentage of the station’s
watering area exposed to rainfall. This setting is adjustable from
None (no rain contact) to 100% (full rain contact) in 25% increments.
For example, about 25% of the station zone is covered by a roof
overhang. The usable rainfall value for this station would be 75%.
Set Station Run Time
The station run time defines how long the station will operate during
the watering cycle. The run time is adjustable from 1 to 99. 9 minutes.
RUNTIME PART 1 STA 01
05.0 Minutes
1. Turn the Upper Line knob to display Runtime Part 1.
2. Turn the Lower Line knob to adjust the whole number value
from 01 to 99.
3. Turn the Upper Line knob right to select the decimal value
(Runtime Part 2).
4. Turn the Lower Line knob to adjust the decimel number value
from 0 to 9.
To Next Page
Loading...
Need help?
General
