EasyManuals Logo
Home>Toro>Utility Vehicle>Workman GTX

Toro Workman GTX Service Manual

Toro Workman GTX
187 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
Workman GTX Gasoline Page 5 11 Electrical System
Machine Fuses
The fuse blocks for the machine fuses are located be-
neath the seat base (Fig. 10).
Fuses can be removed to
check continuity. The test meter should read less than
1 ohm if a fuse is functional.
Fuses protect circuits as follows:
Bottom fuse in the left fuse block (10 amp) protects
the circuit for the USB charge port on the dash. This fuse
also provides circuit protection for the optional power
point, reverse alarm and parking brake alarm.
Second fuse from the bottom in the left fuse block
(10 amp) protects the headlight circuit. The fuse also
provides circuit protection for the optional brake light
and turn signal kit.
Third fuse from the bottom in the left fuse block (15
amp) protects the main power circuits that are con-
trolled by the key switch.
Top fuse in the left fuse block (30 amp recommend-
ed) protects the horn circuit (if equipped).
Top fuse in the right fuse block
Machines with carbureted engine: (15 amp) pro-
tects the rear lift actuator circuit (if equipped).
Machines with fuel injected engine: (10 amp) pro-
tects the delay timer and the engine ECU.
Second fuse from the bottom in the right fuse block
Machines with fuel injected engine: (15 amp) pro-
tects the rear lift actuator circuit (if equipped).
Figure 10
1. Left fuse block
2. Right fuse block
1
2
Engine Fuses (machines with fuel injected engine EFI)
The fuse holders for the engine fuses are located at the
front of the engine next to the engine ECU (Fig. 11).
The
fuses may be located in either fuse holder and can be
identified by wire color. Fuses can be removed to check
continuity. The test meter should read less than 1 ohm
if a fuse is functional.
Fuses protect circuits as follows:
Fuse with red and red wires (10 amp) protects the
unswitched power circuit to the engine ECU.
Fuse with red/white and red/black wires (10 amp)
protects the switched power circuit to the engine ECU,
oxygen sensor, ignition coil and fuel injector.
1. EFI engine
2. Engine fuse holders
3. Engine ECU
Figure 11
G248194
1
2
3
Electrical
System

Table of Contents

Other manuals for Toro Workman GTX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toro Workman GTX and is the answer not in the manual?

Toro Workman GTX Specifications

General IconGeneral
BrandToro
ModelWorkman GTX
CategoryUtility Vehicle
LanguageEnglish

Related product manuals