Chapter
5:
Setting
up
your
TV
Viewing
the
digital
signal
meter
You
can view the digital signal meter in the ANT/CABLE
digital
TV
input source only.
To
view the digital signal meter:
1 Press
M~U
and open the
Setup
menu.
2 Highlight
Installation
and press
@.
3 A new set
of
Installation menu icons will appear, as
shown below. Open the
Terrestrial
menu, highlight
Signal
Meter,
and press
@.
4 Press
..
'Y
....
~
to select the antenna input and digital
channel whose signal you want to check.
Note:
•
The
physical
digital channel
number
listed
in
the
Signal Meter screen
may
not correspond to a virtual
TV
channel number. Contact your local broadcasters
to obtain the RF channel numbers for your local digital
stations.
•
The
signal strength does not change between virtual
channels on the same physical channel.
To
close the screen and return to the Terrestrial
menu:
Highlight
Done
and press
@.
To
return to normal viewing:
Press
Eer
Setting
the
time
zone
The Time Zone setup will allow you to specify the correct
time zone for your region. This feature will allow the TV
status information to show the correct time zone information
(lkW
page 50).
To
set the time zone:
1 From the
Setup
menu, highlight
Installation
and press
@.
A new set
of
Installation menu icons will appear.
2 Highlight
Time
Zone
Setup,
and press @.
3 Press
..
'Y
....
~
to select the region, highlight
Done,
and
then press
@.
After the time zone has been set, you will be asked to set the
current Daylight Saving Time status.
To
set the Daylight Saving Time status:
1 Press
....
or
~
to select
Yes
or
No,
highlight
Done,
and then
press@.
Viewing
the
system
status
To
view the system status:
1 Press
M~U
and open the
Setup
menu.
2 Highlight
Installation
and press
@.
3 A new set
of
Installation menu icons will appear, as
shown below. Open the
System
Status
menu, highlight
System
Information,
and press
@.
4 Press
....
~
to scroll through the menu
bar
to select the
Software
Version
and view the related information.
To
close the screen and return to the Installation
menu:
Highlight
Done
and press
@.
To
return to normal viewing:
Press
EOT.
Reset
Factory
Defaults
To
reset all settings and channels to their factory
default values:
1 Press
M~U
and open the
Setup
menu.
2 Highlight
Installation
and press
@.
A new set
of
Installation menu icons will appear.
3 Open the
System
Status
menu, highlight
System
Information,
and press
@.
4 Press
....
~
to scroll through the menu bar to select
Factory
Defaults.
5 Enter your PIN code (or 0000 if
no
PIN code has been set).
, 6 Highlight
Yes
and press
@.
The
TV will turn
off
automatically after a few seconds. After the TV turns off,
unplug the TV power cord and then plug
it
in again to
complete the reset process.
To
cancel the reset:
Highlight
No
and press
@.
To Next Page
Loading...
Need help?
General
