REMOVAL
-
INSTALLATION
Removal Procedure
1
Remove the lift bracket Wlfork.
2
Disconnect the piping.
3
Remove the front lift cylinder
Installation Procedure
The installation procedure is the reverse of the removal procedure.
Note:
After installing the lift cylinder, follow the steps below.
(1)
Repeat full
-
stroke raising and lowering without load to bleed air and check normal function
-
ing.
(2)
Check the hydraulic oil level, and add if insufficient.
(3)
Adjust the lift chain tension equally on the left and right sides.
To Next Page
Loading...
Need help?
General
