111
3
3-3. Adjusting the seats
Before driving
*
: If equipped
■ Recording procedure
1 Check that the shift lever is in P.
2 Turn the engine switch to ON.
3 Adjust the driver’s seat to the
desired positions.
4 While pressing the “SET” but-
ton, press button “1” or “2” until
the buzzer sounds.
If the selected button has already been
preset, the previously recorded position
● Stop the vehicle on level ground,
set the parking brake and shift the
shift lever to P (automatic transmis-
sion or CVT) or N (manual trans-
mission).
● Do not allow anyone to sit on a
folded seatback or in the luggage
compartment while driving.
● Do not allow children to enter the
luggage compartment.
● Do not operate the rear seat if it is
occupied.
● Be careful not to get feet or hands
caught in the moving parts or joints
of the seats during operation.
● Do not allow children to operate the
seat.
■ After returning the rear seatback
to the upright position
● Make sure that the seatback is
securely locked in position by lightly
pushing it back and forth.
If the seatback is not securely locked,
the red marking will be visible. Make
sure that the red marking is not visi-
ble.
● Check that the seat belts are not
twisted or caught in the seatback.
Driving position mem-
ory
*
This feature automatically
adjusts the driver’s seat to suit
your preferences.
Your preferred driving posi-
tion (the position of the
driver’s seat) can be recorded
and recalled by pressing a but-
ton.
Two different driving positions
can be recorded into memory.
Each electronic key can be
registered to recall your pre-
ferred driving position.
Recording/recalling a driv-
ing position
To Next Page
Loading...
Need help?
General
